These are general, widely used steps for applying a vinyl decal with transfer tape. They are guidance only, not a warranty or a guarantee of results. Results can vary depending on the surface, temperature, and how the decal is applied.
- Clean the surface with rubbing alcohol and let it dry completely.
- Apply the decal at about 50°F or warmer, and out of direct hot sun.
- Use the hinge method with masking tape to position the decal before you apply it. Place the decal where you want it, tape it in place across the center, then apply one side, lift the other side, and apply the rest.
- Squeegee firmly from the center out.
- Peel the transfer tape back slowly at a sharp angle. If any vinyl lifts, stop, press it back down, and continue peeling.
- Work out small bubbles.
- Wait 24–72 hours before washing the surface.
- Avoid car washes and high-pressure spray for a few days.